S-WELD CLEAN Stainless Steel Pickling Gel

• Removes black oxide marks and heat tint during the welding of stainless steel.

• Quick acting single application process

• Can be used on vertical and overhead surfaces.

PHYSICAL PROPERTIES

Boiling Point : N/A
Specific Gravity : 1.15
Water Solubility : Miscible
pH (as supplied) : < 1.0
Appearance & Colour : Opaque, white acidic gel, pungent acidic odour'

BENEFITS
* Quick acting
* One step treatment
* Completely water rinseable
* Convenient size packs - no wastage
* Can be used on vertical surfaces.

DIRECTIONS FOR USE
1. Clean the weld area carefully using a stainless-steel brush.
2. Roll or shake the drum of Weldbrite if possible for 30 seconds prior to opening the container to
ensure a smooth consistency, especially if the product has not been used for a long time.
3. After welding ensure the area to be pickled has sufficient time to cool below 40OC.
4. Apply the Weldbrite gel to the area to be cleaned, using the brush provided or with an acid
resistant spray pump and applicator. DO NOT PICKLE IN DIRECT SUNLIGHT.
5. Application times may vary depending on ambient temperature, the grade of stainless, surface finish or the method of welding. On a hot rolled surface the pickling time may increase by 50%. MIG welds may require longer pickling times than those obtained using covered electrodes. Allow the pickling gel or solution sufficient time to react with the surface. With high ambient temperatures or when longer pickling times are required it may be necessary to repeat the process.

Should the product dry on the surface wash down, dry and repeat the process

1100/30

 

 

 

 

Alternative SKU: 1100/30

Part Number/SKU: picklingpaste1kg

* Product Images are for illustration purposes only, unless otherwise specified colour may be different.